 |
Reduce loading requirements to match generator supply |
|
Shed non-essential loads while maintaining critical processes and lighting requirements |
|
Retrofit existing generator equipment for peak shaving |
|
Generate revenue possibilities, export power to the utility during peak periods |
|
Verify generator performance and ATS status |
|
Record sequence of events to 1 ms for root cause analysis |
|
Automate existing equipment to seek the utility source, control breakers, and keep the electrical system operational |
Utility Cost Reduction
|
Power System Reliability
|
|---|---|
LOAD CONTROL SYSTEMS
----Load shedding and sequencing
| JCAHO
Automatic generator testing and report generation
|
GENERATOR CONTROL
Peak shaving
Import/export
—Load following (utility base loading)
—Generator base loading
| ATO (Automatic Throw Over) SYSTEMS
Utility to Utility
—Main-Tie-Main
—Main-Main
—Open and closed transition
Utility to Generator
—Basic ATS control with breakers
—Momentary Closed Transition
—Extended Closed Transition (ramped load control)
—Maintained Parallel Operation (Import/Export Control)
|
ENERGY BILLING & COST ALLOCATION
| LOAD PRESERVATION SYSTEMS
High speed load shed
Pre-armed load shed schemes
|
LIGHTING CONTROL
| SEQUENCE OF EVENTS RECORDING (SER)
GPS Time synchronization of events
|
Power Management Services provides a complete range of design and operational services including specifying, developing, installing, commissioning, supporting, and training users of power monitoring and control systems and remote power switching systems. Engineers maintain expertise in many areas such as communications, personal computers, protective relaying, automatic control systems, and programmable controllers.
|
System design and bill of material recommendations |
|
Power monitoring and control |
|
WAGES (Water, Air, Gas, Electric, Steam) |
|
Enterprise web-based monitoring |
|
Specification development, drawings, documentation |
|
Enclosure panel design and build |
|
Metering connection verification/testing |
|
Automatic control systems/PLC programming |
|
On-Site installation assistance, component configuration & startup |
|
Turn-key project management |
|
Third party device and communication interfaces |
|
Configured workstations, user software interfaces |
|
Interactive graphic design to mimic facility layout, one-lines, equipment status |
|
Custom software, reports & applications—billing and paging |
This equipment is delivered fully tested with software licenses, monitor, pre-installed PowerLogic/Powerlink™ software and 1 year warranty.
| 9/8/03 | © 2005 Schneider Electric All Rights Reserved |
 |
||||||
|
